unicraft PG-I 8 SR, Инструкция по эксплуатации

Страница: 23 / 66

Care, maintenance and repair
PG-I Series | Version 1.03 23
Step 5: Close the fuel filler cap vent.
Fig. 38: Close the fuel filler cap vent
Step 7: Remove the side cover of the generator
Fig. 39: Remove the cover
Step 8: Open oil filler plug.
Fig. 40: Open oil filler plug
Step 9: Place the oil collecting pan under the engine.
Step 10: Tilt the generator to drain the oil completely.
Fig. 41: Tilting the generator
Step 11: Properly dispose of used oil.
Step 12: Add engine oil through the filler neck. Make
sure that no dirt gets into the oil.
Step 13: Close oil filler plug.
Step 14: Refit the cover.
11.5Clean oil filter
After each oil change, check the oil filter and clean or re-
place if necessary.
Clean or replace the oil filter after 100 hours at the latest.
Fig. 42: Oil filter
11.6Clean air filter
If the air filter is dirty, the engine will not run smoothly
and can be damaged. Clean the air filter after 3 months
or 50 operating hours and replace it annually. When ope-
rating in dusty conditions, clean the air filter more fre-
quently and replace it at shorter intervals.
Step 1: Switch off the generator and let it cool down.
Step 2: Remove the side cover of the generator.
Fig. 43: Remove the cover
Step 3: Remove air filter cover and filter.
Oil Filter