Unicorn Computer ENDAT-3702, Руководство пользователя

Страница: 32 / 62

26
ENDAT-3702 and ENDAT-3902 All-In-One motherboard uses
This allows hard disk controller to use the fast block mode to transfer data to and
from hard disk drive (HDD). Select Enabled only if hard drives support block
mode.
IDE Primary/Secondary Master/Slave PIO
The four IDE IPO (Programmed Input/Output) fields allow setting a PIO mode (0-4)
for each of the four IDE devices which the onboard IDE interface supports. Modes
0 through 4 provide successively increased performance. In auto mode, the system
automatically determines the best mode for each device.
IDE Primary/Secondary Master/Slaver UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive support it
and the operating environment includes a DMA drive (Windows 95 OSR2 or a
third-party IDE bus master driver). If the hard drive and system software both
support Ultra DMA/33, select Auto enable BIOS support.
Onboard FDD Controller
This should be enabled if system has a floppy disk drive (FDD) installed on the
system.
Onboard Serial Port 1/ Port 2 / Port 3 / Port 4
This item allows determining the I/O address and IRQ of the onboard serial port.
UART 2 Mode
This item allows determining which Infrared (IR) function of onboard I/O chip.
Onboard Paral lel Port
This item allows determining the I/O address of onboard parallel port.
Onboard Parallel Mode
Select an operating mode for the onboard parallel port. Normal EPP (Extended
Parallel Port), ECP (Extended Capabilities Port) ECP+EPP PC AT parallel port