UNICORECOMM UB4B0, Руководство пользователя

Страница: 14 / 30

UB4B0 User Manua l
12
5. Start UPRECISE on the PC
6. Refer to UPRECISE online help to send commands or log data for the
receiver
Note: In case the card has not been in use for a long time, or the
distance from last time used location is above 1000Km, a slower fix
may occur. In that case, please use the FRESET command to clear
the older ephemeris and Almanac information (this command will
also clear the Board setup information). After the FRESET command
is executed, the board will be reset, it will take 15 minutes to collect
new ephemeris and Almanac information.
3 PC Utility Configuration （ UPrecise ）
3.1 Overview
UB4B0
Unicore UPRECISE (Control and Display Tool) provides a user-friendly graphical interface to
control and display the operation of your receiver. User can access the functionality and information just
through several clicks
。
UPrecise
The following features are included in UPRECISE
：

Connect the receiver, configure the baud rate

Graphic window for displaying Position of satellite, PRN, and Signal/Noise Ratio
(Constellation View)

Historical and present Trajectory of the receiver and display Position velocity, and
time
（
Trajectory View
）

Graphic interface for data logging, send commands to the Receiver
（
Logging Control
View
）

Console window for sending command to receiver (Console View)