5686G-PRO User Guide
Page
27
of
94
Copyright © 2018 USR, a Division of UNICOM Global
3.
If Dialback is enabled at the host Courier Lite 56K Business Modem’s site, set your modem to
answer the host Courier Lite 56K Business Modem when it dials back.
For your modem to
Command
To answer the Dialback call
ATS0=1
4.
Call the host.
5.
After the call ends you can disable Auto Answer.
For your modem to
Command
Disable Auto Answer
ATS0=0
Configuring Dial Security Remotely
The host administrator can configure the host’s security settings remotely.
Note:
At the host device, you must have previously enabled remote access and assigned a remote -
access password that allows view-and-change privileges (Refer to the
section in this guide). You may want to use your administrative password as your
remote-access password.
Dialing In From the Remote Site
1.
From the remote site, connect to the host using Dial Security. Once a connection is made,
follow the instructions for beginning a remote-access session as described in the Accessing
and Configuring the Courier Lite 56K Business Modem Remotely.
2.
When remote access has been granted, use the
AT%S=
command to access the Dial Security
To view the security account information use
ATI10
.
3.
Make any configuration changes and execute them immediately by entering
AT%C2
.
4.
To end the remote session and reactivate Dial Security on the host, reset the host device by
issuing
ATZ
.
WARNING:
If you do not use the ATZ command to end a remote-access session, Dial Security will
remain disabled at the host, and anyone dialing in to the host for remote access will have access to
the ATI10 screen and all Dial Security accounts.
