Installing Converters into Chassis
Follow the steps below to install modular conver ters into the 10 space
Conver ter Chassis (pn: FEP-593110).
A. Remove the blank bracket from the chassis by rotating screw
counterclockwise. Put the blank bracket aside.
B. Open the rack mount bracket kit. The kit contains two rack mount
brackets and four screws.
C. Use a screwdriver to attach the rack mount ears to both sides of
the modular conver ter.
D. Install the modular conver ter by inser ting it into the chassis
guides and sliding it in until it stops. Press it firmly to seat the
chassis power plug into the modular conver ter receptacle.
E. Gently push the thumbscrews in and turn clockwise to tighten.
Do not over tighten.
Rear Panel
The rear panel contains a power socket. This power socket accepts
DC 9V voltage and minimum 700mA supplied current.
Network Connection
A. Select the appropriate length Categor y 5e or 6 twisted pair cable.
Connect one end of the twisted pair cable to the RJ-45 connector
on the conver ter and the other end of twisted pair cable to the RJ-
45 connector on any 10/100/1000Base-T device.
B. Connect one end of a fiber jumper to the SC connector on this
conver ter and the other end of the fiber jumper to the SC
connector on the other 1000Base-SX/LX device.
C. Attach the power adapter DC jack to the conver ter. Verify that the
Power LED is on.
D. Verify that the UTP “LK/ACT” LEDs light when cable connection is
installed correctly. Verify that Fiber “LK/ACT” LED blinks to indicate
network activity.
5
6
DC IN
Auto MDI/MDIX
10/100/1000
T
100Base-S
X
SPD
Multi-Mode
Giga Fiber Converter
10/100/1000
Giga
LK/ACT
FDX/COL
SPD
PWR
1 2 3
ON
Multi-Mode
Giga Fiber Converter
10/100/1000
Giga
LK/ACT
FDX/COL
SPD
PWR
1 2 3
ON
Fiber
1000Base-SX/LX
UTP
10/100/
1000Base-T
UTP
10/100/
1000Base-T
10/100/1000Base-T Port
( RJ-45 connector )
on switch/workstation
10/100/1000Base-T Port
( RJ-45 connector )
on switch/workstation
