3
Revised 05/08/21
01865 767676
www.unicol.com
STEP 1
Connect base to mast as shown (4 fixings for
RH100 and 6 for HD versions).
For a stand version, insert the plastic feet. For a
trolley version, tap castors with the rubber mallet
until they lock into place (ensure braked castors
are at the front).
For bolt down or floor-to-wall base
instructions, please see page 5.
STEP 2
Unlock and lift out rear door. Remove upper rear
panel by unscrewing 4x M6 screws.
For RH200, please continue on page 6.
STEP 3
Place 2x screws in the bottom two rivnuts of the
mount back plate and slot into chosen keyholes in
mast. From the rear, screw in top two screws into
the back plate and fully tighten all 4 screws.
STEP 4
Feed cables for screen through hole in backplate
and front of mast and down through cable access.
Refit rear top panel using x4 M6 screws. Refit rear
door and lock.
