01865 767676
www.unicol.com
3
Revised 26/04/24
STEP 1
Using the 6 wall mounting slots cut out on the back
plate, determine where you want to install your
mount, mark it and fix into position. Please ensure
that the side with a small notch is at the top as
shown above.
Please consider cabling and wall fixings prior to
installation. Please check surface is capable of
supporting 5x the combined solutions weight.
STEP 2
A separate universal mount (PZX) is provided to
mount your screen to the PLS or PLA. Separate
instructions are provided with each screen mount.
Follow these to mount your screen onto the mount
backplate
Fix the PZX backplate to the head of the PLS/PLA
using the M10x25 hex head screws provided.
STEP 4
Utilising the tag locks and fixing pack provided with
your mount, attach the arms to the back of your
screen.
Ensure the arms are the correct way up before
tightening - the ‘hook’ part of the arm should be at
the top.
STEP 3 (FOR PZX9)
If using a PZX9 for the PLA2X9, there will be an
additional converter plate included. This will need to
be attached to the back of the PZX9 and then to the
arms on the mount backplate.