unication G4, Настройка

Страница: 11 / 14

Page 11
APPENDIX
In the following several examples will be provided to help understand the settings for different
behaviors
.
1. Selective Call Mode
In this mode, the pager is mute until a programmed QCII ID is decoded. Once
decoded the pager will generate the alert assigned to the QCII ID and after the alert
cycle the voice message is played. After the message is heard the pager will go mute
awaiting any traffic on the TGID assigned the QCII IDs.
Key programming settings to configure the G4/5 for Selective Call Mode are shown in
Figures 1A-5A below. Below, several of the Key settings are reviewed.
a. Voice Prompt - This is not a key setting, but may be useful for the User. In in this
a prompt labelled Selective Call using the Custom Voice Prompt button was
created.
b. Binding Feature - Sub-Group Feature must be selected.
c. Reset Mode - Selective Manual Reset must be selected.
d. Delay N Function - To ensure the received voice message is stored this must be
enabled.
e. Delay N Timer - This setting works in tandem with the Delay N Function. The
value selected is to cover any gap in a voice transmission after the QCII ID is
sent and ensure the voice message is stored.
f. Talk Group List - (Figure 2A) Select the TGID to be used for QCII transmissions.
g. Binding Setting - Located at the bottom of the Talk Group List, click on Sub-
Group Setting and a list showing the TGID is displayed. Click on Edit and Figure
3A will be displayed. It is here where one selects the QCII IDs to decode.
NOTE: The Alternatives setting cannot be selected.
h. Revert Talk Group List- Select the TGID to be used for QCII transmissions
(Figure 4A). Located at the bottom of the Revert Talk Group List, click on Sub-
Group Setting and a list showing the TGID is displayed. Click on Edit and Figure
5A will be displayed. Selects the same QCII IDs to decode that were selected in
the Talk Group List.
NOTE: The Alternatives setting cannot be selected.