Unical 001104, Инструкция по эксплуатации

Страница: 6 / 8

6
EN
Display Kind of problem Solution
AL01 no ignition
The stove cannot ignite
at the fi rst start-up Fill the tank with pellets
Start up again
AL02 defected NTC sensor
The ambient sensor is broken
or not connected to the PCB
Contact an Authorized Assistance Center
AL05 no pellet
The stove switched off
during the work phase Fill in the tank with pellets
Clean the brazier and restart the stove
AL06 pressostat Obstructed fl ue pipe
Clean the fl ue pipe or check that there are no
obstructed grilles at the exit of the smoke outlet
AL07 thermostat The stove is overheated
Wait for the stove to cool down. Reset the
thermostat manually.
If the problem per-
sists, contact an Authorized Assistance
Center
AL08 black out There is no power supply
As soon as the power supply is back, the
Stove starts a cooling cycle. After completing
the cycle it starts working automatically
AL09 smoke motor
Smokes extractor blocked
or broken
Contact an Authorized Assistance Center
AL10 smoke temp. Smokes temperature too high
Switch off the Stove, allow it to cool down
and perform ordinary cleaning.
If the
problem persists, contact an Authorized
Assistance Center for cleaning the Stove
and the fl ue
AL11 smoke probe
The smokes sensor is broken
or not connected to the PCB
Contact an Authorized Assistance Center
AL12 PBC over temp.
Temperature PCB too high
Switch off the Stove, allow it to cool down
and perform ordinary cleaning.
If the
problem persists, contact an Authorized
Assistance Center for cleaning the Stove
and the fl ue
AL13 cochlea error Faulty cochlea motor Contact an Authorized Assistance Center
Alarm signal
Technical menu
Main
User
Tech Tech
NB: The technical menu is a menu reserved for authorized technicians.
Tampering with the parameters in the technical menu by the end user
voids the warranty.
Co
d
.
0
01
10
4