Health & Safety Data Sheet
Uni-Aqua Wash UAW-100/ Uni-Clean UC100
PHYSICAL AND CHEMICAL PROPERTIES
Appearance
Bright yellow, clear liquid
Odour
Slight detergent odour.
Ph
Neat : 13.0 10% : 12.2 1% : 11.2
Density@20°C
1.02 g/ml
Flash point
Non-flammable
Solubility in Water
Soluble in all proportions.
COMPOSITION/INFORMATION ON INGREDIENTS
A blend of surfactants and solvents, alkali builders and chelating agents
Substances
Concentrations
Risk Phrases/Symbols
Sodium metasilicate
1-5%
Corrosive R34 CAS No: 6834-92-0 EINECS No: 229-912-9
Non-ionic surfactants
5-10%
Harmful R22,41 CAS No: 68439-46-3
2-(2-butoxyethoxy) ethanol
1-5%
Irritant R36 CAS No : 112-34-5 EINECS No :203-961-6
HAZARDS IDENTIFICATION
The product is classified as being IRRITANT; those materials listed above as Harmful or Corrosive are present at levels low enough to ensure
that the formulated product is classed as ‘Irritant’.
STABILITY AND REACTIVITY
Stable under normal conditions of use and storage. If involved in a fire, will generate sooty deposits plus the oxides of carbon and nitrogen.
HANDLING AND STORAGE
Store between 0 and 30° C in the containers provided and replace closure after use. Do not mix with other chemicals. Wear safety glasses
and gloves when handling neat or dilutes product. If the diluted product is sprayed in significant quantities or used through a high pressure
washer, then also wear a waterproof suit and rubber boots.
FIRST AID MEASURES
Eye Protection
Wear splash-proof eye goggles to prevent any possibility of eye contact.
Skin Protection
No specific hand protection noted, but gloves may still be advisable.
Respiratory Protection
Not Required. Normal room ventilation is adequate.
EXPOSURE CONTROLS/PERSONAL PROTECTION
Wear rubber gloves and safety glasses when handling the neat or diluted product.
Workplace Exposure Limits (WELs):
Sodium metasilicate as a dry powder has been allocated an STEL of 2mg/cubic metre.
The product contains ~2%w/w of this material in aqueous solution.
FIRE FIGHTING MEASURES
Non-flammable and will not support combustion. If drums are involved in a fire, then spray with water to cool.
ACCIDENTAL RELEASE MEASURES
Contain spillage and absorb onto dry earth, sand or granules. Scrape up and place into suitable plastic containers. Flush the affected area
with water.
DISPOSAL CONSIDERATIONS
For the disposal of large quantities, consult the local authority for advice; Small amounts may be disposed of via the foul sewer where it will
be successfully treated by the local water treatment plant. Do not allow product to enter the surface drainage system.
TOXICOLIGICAL INFORMATION
Contact with eyes
Causes irritation, redness and watering.
Contact with skin
Prolonged contact causes dryness and irritation due to loss of natural skin oils.
Ingested
Will cause soreness to mouth and throat. May cause an upset stomach.
Inhaled
If mist or spray is inhaled, will cause irritation of mouth, nose and throat.
REGULATORY INFORMATION
The preparation requires a formal COSHH assessment which should ensure that employees are aware of hazards/precautions detailed in this
date sheet. The COSHH assessment should also ensure that recommended safety equipment is available and, where applicable, the
exposure limits detailed under exposure controls are not being exceeded.
Label for supply:
Risk Phrases
R36/38 Irritating to eyes and skin
Safety Phrases
S24/25 Avoid contact with skin and eyes. S26 In case of contact with the eyes, rinse immediately with
plenty of water and seek medical advice.
S37/39
Wear suitable gloves and eye/face protection.
U.K.Regulatory References:
The Chemicals (Hazard Information and Packaging for Supply) Regulations 2009. The carriage of
Dangerous Goods and Use of Transportable Pressure Equipment Regulations 2007 aligned with ADR.
Workplace Exposure Limits EH40.2005 and subsequent amendments.
REACH
Regulation 1907/2006/EC effective June 1st, 2007. The raw materials used in this preparation have
been pre-registered in accord with the requirements of REACH.
OTHER INFORMATION
It is the responsibility of the user to ensure safe working conditions. The health hazards and general information contained within this Material
Safety Data Sheet are given as a guide to the precautions required to maintain a safe working environment.
Full details of the Risk Phrases used in information on ingredients and not subsequently covered are given below:
R22 Harmful if swallowed. R34 Causes burns. R41 Risk of serious damage to eyes.
This is a safe, general purpose hard surface cleaner with a wide area of applications. Used at between 1 – 10% w/w depending upon degree
of soiling.