Quick Guide
UPO1000 Series
9/17
3.
Getting Started Guide
This chapter is to introduce on using the oscilloscope for the first time, the front and rear panels, the user
interface, as well as the built-in help system.
3.1 General Inspection
It is recommended to inspect the instrument follow the steps below before using the UPO1000 series for
the first time.
(1) Check for Damages caused by Transport
If the packaging carton or the foam plastic cushions are severely damaged, please contact the UNI-T
distributor of this product immediately.
(2) Check Attachment
Please check appendix for the list of accessories. If any of the accessories are missing or damaged,
please contact UNI-T or local distributors of this product.
(3) Machine Inspection
If the instrument appears to be damaged, not working properly, or has failed the functionality test,
please contact UNI-T or local distributors of this product.
If the equipment is damaged due to shipping, please keep the packaging and notify both the
transportation department and UNI-T distributors, UNI-T will arrange maintenance or replacement.
3.2 Before Use
To perform a quick verification of the instrument’s normal operations, please follow the steps below.
(1) Connecting to the Power Supply
AC power specification of UPO1000 series digital storage oscilloscope refers to
Supply
section. Use the assembled power line or other power line that meets the local country
standards to connect the oscilloscope. The power soft indicator
in the left bottom on front
panel is extinguished and this soft switch key is no-effect when the power switch on rear panel is not
opened. The power soft indicator
in the left bottom on front panel is illuminated with red and
then press the soft switch key to enable the oscilloscope.
(2)
Boot Check
Press the soft power key
and the indicator should change from red to green. The oscilloscope
will show a boot animation, and then enter the normal interface.
(3)
Connecting Probe
Use BNC of the port to connect to BNC of CH1 of the oscilloscope. Connecting the probe to the “probe
compensation signal connection clip” and connecting the ground alligator clip to the “ground terminal”
under the “probe compensation signal connection clip”. The output of probe compensation signal
connection clip is the amplitude about
3Vpp and the frequency defaults to 1 kHz.
