8
MANUAL - SOLVENT RECYCLER - URS900SSW
Revised 2011-07
6) Recycling
On fi rst power up and when the unit is ready to begin a new cycle, the Display Panel shows
“READY S.P. = XXX°C” (S.P. = SET POINT). When Setup is complete and START has been pressed,
the “HEAT” light comes on and the recyling process begins.
During the boiling phase, 3 temperatures
will alternate on the Display: “SET-PT”, “TANK” and “VAPOR EX.”
When the boiling phase is complete,
“COOLING” will be displayed. Note: the fan may still be running; this is normal as it continues to run until
the temperatue drops below 50°C. To cancel the cycle, press the “START/STOP” key.
7) Finish Recycling
CAUTION: DO NOT OPEN LID UNTIL COOLING IS COMPLETE
The clean, recycled water is available for use when the display shows “READY S.P. = XXX°C”.
Note: during the cooling phase, the display will show “COOLING T = XXX°C” (T = TEMPERATURE) and
the fan may still be running; this is normal as it continues to run until the temperatue drops below 50°C.
8) Remove the pail of distilled water and replace with an empty pail.
9) Remove Debris:
Remove the Retainer Ring and slowly pull the Liner Bag containing the debris out of the distillation tank in
a way that the Liner Bag does not break. Dispose of the debris in accordance with local regulations.
NOTE: If the bag sticks to the bottom of the tank, turn the recycler on for 5 minutes to loosen the bag from
the bottom of the tank, then lift the bag out while the bag is warm.
10) Clean Distillation Tank and Lid Surface
Distillation Tank:
Wipe inside the Tank with a cloth.
Remove any remaining debris from the Distillation Tank using if necessary, plastic or wooden tools (not
supplied). Do not clean with abrasive or hard metal instruments that can damage the tank. The warranty
does not cover such damage.
Note:
There may be some dirty water remaining in the Distillation Tank after recycling due to condensa-
tion. This material, If left in the tank, can cause corrosion. In addtion, dirt and debris left in the tank can
prevent full heat from reaching the dirty water during recycling.
Lid Surface:
Use a cloth. Dry and clean the lid and the top of tank where the the Lid Gasket sits to extend the life of the
Lid Gasket and prevent leakage. Avoid rotating the lid during cleaning. The lid gasket is a wear item.
11) Check the Tank Filter and replace if it is dirty (Part No. 900-1117FP).
Note: Replace the Filter at
least once a month.
12) Install a new Liner Bag
Lift Recycler Safety Cover and Tank Lid fully; lids will stay in the open position.
a) Remove the Tank Screen and Filter
b) Install the Liner Bag so that the bottom of the Bag sits fl at on the bottom of the Distillation Tank as
shown. With thumb and index fi nger, squeeze the Retainer Ring and insert into inside of the Liner Bag.
Let go and make sure it fi ts securely in the groove.
c) Fold the fl ap of the liner bag over the retainer ring.
d) Replace the Tank Screen and Filter.