MANUAL - WALL MOUNT WATERBORNE GUN CLEANERS - UM80 SERIES REVISED 2015-5-30
2
SETUP
INSPECTION
•
Report any transport damage immediately to the carrier and your vendor. Initiate a freight claim with
the carrier. The manufacturer is not responsible for freight damage.
• Accessories:
•
Manual
• Coag-Kleen FP, flocculant granules (WF Model only)
•
Air Blow Gun
• Aqua-Kleen Cleaner
•
Whip LIne Coupler
PLACEMENT AND AIR SUPPLY
• Mount the unit to a wall (hardware not included) in a Spray Booth or another convenient location in
the shop.
• Remove the cover on the "Air Input" (right side of machine) and attach an air supply adapter (not sup-
plied).
• Remove the Air Blow Gun from the acessories bag and place it onto the bracket on the right side of
the unit. Connect the air supply tube (blue) to the Air Blow Gun Fitting by inserting the tube. To dis-
connect the tube, push down on the collar and pull the tube out.
UM80W, WF and WA (Water) Models
• Attach the Whip Line Coupler to the orange line on the left side of machine and to your spray gun using
a a quick connect fitting (not supplied) on the Spray Gun.
UM80S (Solvent) Model
• Connect the air supply tube (blue) to the blue fitting by inserting the tube. To disconnect, push down on
the collar and pull the tube out.
CAUTION
• The air supply must be free from contaminants such as water, dust, rust, tar, grease etc.
• To prevent damage to the Diaphragm Pump an internal Air Pressure Regulator has been installed to
limit the air pressure. The pressure must be maintained at 60 PSI for waterborne units and 85 PSI for
the UM80S. Do not install a second air pressure regulator.
PAIL SETUP and ADDITION OF UNI-RAM AQUA-KLEEN
Aqua-Kleen is a state-of-the-art cleaning additive with an enhanced corrosion inhibitor for optimal protec-
tion of spray guns.
UM80W / UM80WA
Two 5-litre bottle-type containers are included with the unit.
• Fill one container with clean water and add half of a bottle of Uni-ram Aqua Kleen.
INTRODUCTION
Uni-ram holds many patents on designs used in its innovative products. Every machine is tested
for compliance with Quality Assurance standards. Follow the directions in this manual under Setup,
Operation and Maintenance in order to operate this machine safely and effectively. Not following these
instruction can lead to malfunction or damage to the machine. Follow directions under the section
below, Cautions and Warnings and on labels attached to the machine. Ensure that the manual is read-
ily available to the operator at all times. If you have any questions about the operation of this machine,
call your distributor or a Uni-ram Service Engineer:
North America: Uni-ram Technical Service 1-800-417- 9133
Other Continents: Contact Your Supplier
