5
MANUAL - SPRAY GUN CLEANERS - UG5000W SERIES
Revision 2013-02
GROUND WIRES
Connect the external ground wire (right side of cabinet) to an external grounded object.
LEVELING, VENT AND AIR SUPPLY
•
Level the machine using the adjustable legs.
•
Remove the cover on the "Air Input" (right side of machine) and attach an air supply adapter
(not supplied).
•
If necessary, replace the female quick connect on the Whip Air Line with a quick connect that
will fit the male quick connect of your spray gun.
The air supply pressure must be at least 85 PSI and the air must be free from contaminants
such as water, dust, rust, tar, grease etc.
To prevent damage to the Diaphragm Pumps an internal Air Pressure Regulator has been
installed to limit the air pressure to precisely 85 PSI. Do not install a second air pressure regu-
lator or use a pressure set below 85 PSI.
INSTALL BLOW GUN, WASH GUN AND WHIP LINE COUPLER
Remove the Blow Gun, Wash Gun and Whip LIne Coupler from the Acessory Kit bag
(inside the tank) and install on the unit by inserting the appropriate air tubes into the tools
and hanging them on the brackets (Blow Gun and Wash Gun on the right side and Coupler
on the front). Use the labels below the tubes as a guide.
SOLVENT SELECTION
The adhesion quality of automotive paint has dramatically improved in recent years. The
choice of solvent is critical. Only use good quality solvent that is formulated for your paint
and intended for use with automatic spray guns cleaners.
PAIL SETUP (LEFT SIDE, SOLVENT)
•
Open the door to the base cabinet
•
Combo Ready units (UG5000EW, UG5500EW) come with the pails already installed as shown.
Transfer Hoses are provided with Uni-ram Solvent Recyclers designed for Combo operation
(EP2 models). The UG5000W and UG5500W do not come with a Riser or Overflow Tube. The
Riser and the Overflow Tube are not needed for stand alone operation.
•
The left pail has intake tubes for both manual washing and the auto wash cycle plus a black
drain hose. If necessary, open the Drain Valve under the left tank (vertical position) and fill this
pail 2/3 full (3 Gal) by pouring solvent into the tank and letting it drain into the pail. Insert the
Rinse Pump into a pail of clean solvent (not supplied) and place the
pail inside the cabinet.
PAIL SETUP and ADDITION OF UNI-RAM AQUA-KLEEN
(RIGHT SIDE, WATER)
Aqua-Kleen is a state-of-the-art cleaning additive with an enhanced corro-
sion inhibitor for optimal protection of your expensive spray guns.
•
Open the door to the base cabinet
•
Move the Drain Valve handle to the "closed" (horizontal) position if it
is not already there.
