background image

 

TECHNICAL SPECIFICATIONS

 

 

Transmission mode 

 

: UHF stereo 

Carrier 

frequency 

  : 

900MHz 

Operating voltage  

 

: Transmitter – 12 V 200 mA 

Receiver  – 2.4 V (two rechargeable batteries, 

LR03/AAA size) 

Frequency response 

 

: 30 Hz – 11 KHz 

Distortion 

 

 

  : 

<1.5% 

Signal-to-noise ratio 

 

: >50 dB 

Channel separation 

 

: 30 dB 

Range 

 

 

 

: 50 meters (open area) 

 

Caution:  

Changes or modifications to this unit not expressly approved by the party 

responsible for compliance could void the user’s authority to operate the equipment.   

Operation is subject to the following two conditions: (1) this device may not cause 

interference, and (2) this device must accept any interference, including 

interference that may cause undesired operation of the device. 

 

 

 

 

 

 

 

 

 

 

9

TROUBLE SHOOTING 

NO SOUND 

-

 

Ensure that the mains adapter is pushed fully into the power outlet and 

that its cable is properly connected to the DC IN 12V connector on the 

transmitter. 

-

 

Ensure that the headphones On/Off switch is switched to the On 

-

 

The headphones battery charge level may be too low. Recharge the 

batteries or replace them with fully charged batteries. 

-

 

Ensure that your TV set, Hi-Fi system or audio component is switched 

on and set to a channel that broadcasts an audio signal. 

-

 

Use the headphones volume control to increase the sound level. 

-

 

The connected audio/video equipment may not be in playback mode. 

Start playback on by the equipment. 

-

 

The headphones output level is set too low. Adjust the volume to a 

suitable level. 

DISTORTION 

-

 

Ensure that the "Stereo" indicator is lit. If not, adjust the tuning control 

(Auto Scan) on the headphones until it lights. 

-

 

Use the channel selector to change the transmitter's transmission 

frequency. Then you will need to adjust the tuning control on the 

headphones until the "Stereo" indicator comes on. 

-

 

The headphones battery charge level may be too low. Recharge the 

batteries or replace them with fully charged batteries. 

-

 

Ensure that the volume knob setting is correct. 

-

 

The headphones may be too far away from the transmitter. Move closer 

to it. 

-

 

The audio signal input level is too low. Increase the volume 

from the audio source.

 

Содержание HP4390






Отзывы: