ungerglobal.com
Installation &
Operating Instructions
12
Operation
1. Periodically inspect the HydroPower system during use. Ensure hoses are
properly attached. Inspect system for leaks and proper fit of top cap assembly.
2. Take care when working to ensure there is enough slack in waterfed wash pole
hose. This hose is connected to the top of the unit and excessive tugging may
cause the system to tip over.
3. Drinking water flows into the system’s lower connection port via tap pressure
and flows upwards through the HydroPower tank. Pure water exits through the
top connection. When plumbing line pressures fall below 40psi, a reduction in
flow rates will be noticeable.
4. The on/off valve can be used to adjust water flow rates coming out of the
waterfed wash pole brush jets. Excessive flow from the brush head jets can
cause water splattering from uncleaned glass back onto previously cleaned
areas, resulting in spotting.
System Specifications
Model
HP06T HP12T/HP12C HP24T/HP24C
DI Resin Capacity
1 bag - 6.0l/0.21 cu. ft.
2 bags - 12.0l/0.42 cu. ft.
3 bags - 24l/0.84 cu. ft.
Power
Tap Pressure
Tap Pressure
Tap Pressure
Pump
NA
NA
NA
Working Hose Length
100 ft./30m plus
100 ft./30m plus
100 ft./30m plus
*All values based on 10 ppm as maximum for pure water quality.
Pure Water Production
*
Soft
< 100 ppm
>
414 gal / 1,570l
>
830 gal / 3,140l
> 1,680 gal / 6,360l
Medium
100 – 250 ppm
124 gal - 414 gal /
299 gal - 830 gal /
647 gal - 1,680 gal /
470l - 1,570l
1,130l - 3,140l
2,450l - 6,360l
Hard
250 – 400 ppm
69 gal - 124 gal /
177 gal - 299 gal /
394 gal - 647 gal /
260l - 470l
670l - 1,130l
1,490l - 2,450l
Very Hard
>
400 ppm
<
69 gal / 260l
<
177 gal / 670l
<
394 gal / 1,490l
Water
TDS Reading
HP06
HP12
HP24
OUTPUT
