unGer nLite Hydro Power HP06T, Инструкция по установке и эксплуатации

Страница: 7 / 16

System Overview
•
Unger nLite HydroPower systems contain mixed bed ion exchange resin to
“filter” impurities out of ordinary drinking water, converting it into a powerful
cleaning agent commonly referred to as PureWater. Such impurities are
referred to as total dissolved solids (TDS) and are measured in parts per
million (ppm). Water is considered 100% demineralized or pure when its
TDS is measured at 0.00 ppm. The average TDS of drinking water is 180 ppm.
Pure Water attracts dirt and impurities from the surface being cleaned,
holding it in solution. This solution of captured dirt is then carried away,
leaving only Pure Water on the surface where it will dry to a clean and
spot-free appearance.
•
No power is required other than drinking water
line pressure, which typically ranges from 40 to 60
psi. This enables the system to produce Pure Water
at up to 1.5 gallons per minute. The production of
Pure Water is not sensitive to water temperatures.
Unger recommends testing the water supply (TDS)
before working.
•
Mixed bed ion exchange resin eventually becomes
exhausted and no longer able to remove impurities.
The nLite HydroPower systems incorporate an
on-board TDS (total dissolved solids) meter. TDS is
a measure of how pure the water is. Water that
contains zero TDS is considered Pure Water and
ideal for cleaning. When TDS levels reach
over 10 ppm, the resin should be replaced.
Changing the QuickChange
TM
Resin Bags is
quick and easy:
1. Remove top cap assembly by 1/4 turn,
pull off cap.
2. Lift out resin bag(s) and replace
with new bag(s).
3. Re-install top cap.
Installation &
Operating Instructions
7