[Unex] - Ver. 2.7 20130401 P. 8
Unex Technology Corp.
- Durable Bridge to Wireless
http://www.unex.com.tw
Specifications:
Antenna
three DIP MMCX RF connector for robust antenna assembly
Remark: please make sure to install three antennas on these three antenna ports before
power on. For less than three antennas application, a 50 ohm terminator (or Unex’s
ACMCX-2) on each opened antenna port is required before power on. This is a high-
power module, PA will be damaged and cause DC-shorted if leave antenna port open
during transmission.
MAC Protocol
CSMA/CA with ACK architecture 32-bit MAC
Security
▪ 64-bit, 128-bit and 152-bit WEP encryption
▪ 802.1x authentication
▪ AES-CCM & TKIP encryption
Operation Systems
Supported
▪ Linux
▪ Atheros Linux SDK for AP and client-mode sub-license available by project.
Frequency Tolerance
transmitted center frequency tolerance ± 20ppm max.
Dimension
65.8mm (L) x 59.6mm (W) x 1.0mm (T)
Operation Temperature
Range
-40˚C ~ +75˚C
Storage Temperature Range
-40°C ~ +80°C
Operating Humidity
10% ~ 95%, non-condensing
Storage Humidity
max. 95%, non-condensing
Environment-Friendly
Compliance
REACH and RoHS
Ordering Information:
DNMA-H5
Industrial-grade, high-power 802.11n a/b/g wifi 3x3 mini-PCI module w/ESD and Surge Protection,
AR9160-BC1B+AR9106
ESD Cable
UL 1007 18AWG, length 19cm, for ground end to enclosure point tied to Earth Ground.
ACMCX-2
50 Ohm MMCX terminator
Important Notices on Application
1. Please make sure to install three antennas on these three antenna ports before power on. For less than three
antennas application, a 50 ohm terminator (or Unex's ACMCX-2) on each opened antenna port is required before
power on.
2. Please do not transmit power levels exceed max. target power in EEPROM's setting.
3. Please follow Unex’s instruction document of single carrier test if test conducted.
