Uneek 4x4 GU-RB-ASM5, Инструкция по монтажу

Страница: 17 / 20

Fit striker pin finger tight and leave M12 button
head cap screws loose at this point. Fit latch to
swing arm with M6 hardware. Swing arm into
closed position to line up the latch. Raise/lower
striker pin plate and move pin left or right until
there is a clean opening and closing feeling.
Torque all bolts once that is achieved.
Fit latch cover and actuation lever. Fit spring
from latch to hole in cover shown by arrows.
Fit rubber stopper with M6 button head cap
screw so that it compresses when fully closed.
You may need to add washers to ship out the
stopper to get good compression to prevent
rattling.
If fitting spare tyre on the LH side follow the
same steps as before.