GrandFinale-0250-0413-V03
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2013 UMI. All rights reserved. ® and TM designate
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Do not dispose of batteries in fire. Battery may explode or leak.
Operation
LIVE Mode
In this mode, each time you press a launch button, the
corresponding cone or cones fire immediately.
Press any one of the five launch buttons individually or press
any combination of buttons 1, 2, 3, 4 or 5 at the same time.
You can also press the “ALL 5” button to launch all 5 firework
cones at the same time!
Experiment and have fun creating hundreds of different
Firework launch and color combinations!
PROGRAM Mode
In this mode, you can program up to 150 launch
combinations in a show by doing the following:
1. Switch the Master Controller to “PROGRAM” mode.
2. Press any one of the five launch buttons, any combination of buttons 1, 2, 3, 4 or 5, or the “ALL 5” launch button to program the first launch.
3. Continue to add as many additional launches to your show program as you want by pressing single button launches, multi-button launch
combinations, or the “ALL 5” launch button. Experiment and have fun with different launch button combinations and sequences.
4. To run your program and begin the show, press the Program Launch button. For even more fun, turn on your favorite music while playing your
Grand Finale show! You can stop your programmed show at any time by pressing the Program Launch button again. Press again to replay the
show from the beginning. You can continue to add additional launches to your current program until the memory is full.
5. When the memory is full and you have programmed the maximum number of launches, the Master Controller and all five cones will light up
and remain on for 3 seconds.
RESET Program
At any point you may press and hold the RESET button for about 1.5 seconds to clear your program and begin a new one. The Master Controller
will flash three times to confirm reset. Note: If you do not push the RESET button on the Master Controller, your program will remain in
memory until you turn off the center cone. The program will also be cleared from memory if you change the batteries in the center cone.
COLOR MODE Button
As fireworks are launching either in LIVE or Program Mode, press the Color Mode button anytime to change the colors of the firework lights. Each
time you press the color mode button, it will change to a different array of colors.
COLOR
MODE
PROGRAM
RESET
LIVE
OFF
Program/Live/Off
Reset
Color
Mode
Launch
Buttons
All 5 Launch
Program
Launch
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit unclemilton.com
Master Controller
