UNAOHM
22
EP2500 (Rev. 0)
7.10
DiSEqC
The instrument can drive peripherals in conformity with the DiSEqC 1.1 and 1.2 protocols.
Figure 7
DiSEqC command selection display
7.10.1
How to Engage the 22 kHz Tone
1
Press the key
DSQ (28)
.
Figure 7
is displayed on the screen.
2
Use the keys
UP
or
DOWN
to position the cursor in correspondence with the 22 kHz reading.
3
Press
DSQ
to alternately enable/disable the tone. The presence of the signal is indicated on the OSD
display.
4
Once the function has been performed, the instrument returns to the normal operating mode.
7.10.2
Transmission of a DiSEqC 1.1 Command
1.
Press the key
DSQ (28)
. The display in
Figure 7
will appear.
2.
Use the keys
UP
or
DOWN
to position the cursor in correspondence with the DiSEqC reading
followed by the name of a command.
3.
Press
↵
ENTER (21)
to transmit the command indicated. Immediately following transmission the
cursor shifts to the other command available, which in turn may be transmitted by means of
↵
ENTER
and so on thereby making it possible to rapidly transmit two commands alternately.
4.
To simply transmit the command indicated and return to the normal operating mode press
DSQ
or
BACK
.
At the previous point 3, to transmit a command different from the one selected, proceed as follows:
1.
Press the key
SELECT
.
Figure 8
appears on the display screen.
2.
Select the command to be transmitted by means of the keys
UP
or
DOWN
.
3.
Press
↵
ENTER
to transmit the command while remaining in the same menu or
DSQ
or
BACK
to
transmit the command and return to the menu in
Figure 7
which will have been up-dated to include
the new command.
NOTE
:
DiSEqC is engaged oly when power to the LNB in SAT band is engaged. The complete DiSEqC
list os commands is found in Appendix A.
7.10.3
DiSEqC 1.2 for Steerable Dishes
DiSEqC 1.2 commands make it possible to control the position of a steerable dish.
DiSEqC
SELECT
DOWN
UP
BACK
MENU DiSEqC
DiSEqC1 SW1 OFF l LO
DiSEqC2 SW1 ON h LO
22 kHz ON
