UMS POWER TUG, Руководство по эксплуатации и обслуживанию

Страница: 7 / 13

CHARGER
The above photograph shows the Guest 2620 charger as installed in the PowerTug It is located under the lid of
the battery compartment. In-line 15A fuses are fitted. Only use replacements of the same type and rating.
DO NOT ATTEMPT TO MOVE THE POWERTUG WHILST “ON-CHARGE”
USE OF AN EARTH FAULT PROTECTED MAINS SUPPLY IS REQUIRED.
REPLACE FUSES ONLY WITH THE SAME TYPE AND RATING
Led indicators are provided for both 12V batteries, which are connected in series to supply the Power Pusher.
These batteries are individually connected to the two charger outputs.
When the RED Led is illuminated the battery is discharged. The charger is recharging at the “Bulk” charging rate
of 10A Voltage is between 11.8 and 14 volts
When both LEDs are illuminated the charger is recharging at an absorption rate between 3 and 6 amperes.
Voltage will be approximately 14V.
In either case if the LEDs remains ON for more than 48Hrs refer to the troubleshooting section.
With only the green LED illuminated the battery has reached almost full charge and the charger is delivering “top-
up” at less than 3 Amperes.
The charger circuitry is designed to prevent overcharging.