3. Install your components - do this before installing the side plates.
a. FC/ESC Stack - Use the included M2x10 screws and a combination of M2 nuts and washers to mount
your FC/ESC stack (middle set of 20x20 mounts). The hardware is meant to
supplement
the
hardware that comes with your FC to help you mount the stack as
low
as possible. Do NOT use
plastic screws through the main plate. Plastic screws can break in a crash.
i.
Below is an example of the Hobbywing Nano Stack. I used the M2 nut and a washer for the
ESC board to sit on, and then used the plastic standoff included with the stack to mount the
FC.
ii.
If you’re FC does best with NO soft mounting, first try the black grommets (they are very stiff).
iii.
You can also skip the FC grommet altogether if your FC/ESC stack uses M3 screws, or if you
would like to simply hard-mount your stack.
b. HD Cam Board (Runcam) - use the included M2x5 screws to mount the board(s) in the front 20x20
mounts. The HD cam/board should include hardware to complete the installation.
c. Camera - use the included M2x8 screws, M2 washers, and 3mm M2 spacer to mount the camera to
the side plates.
It would be easiest to do this in the last steps when you assemble the frame
together.
Содержание Acrobrat
Страница 1: ...Quick Start Guide...
