UMC X216/17C-GB-FTCD-UK, Руководство пользователя

Страница: 12 / 36

10
GETTING STARTED - INITIAL SET UP
TUNING IN
IMPORTANT — Please ensure the TV has
reached room temperature before
connecting the power for the first time
1) Connect the mains lead to your electrical outlet
2) Connect the RF cable supplied to the
'RF IN ' on the rear of the TV and connect
the other end of the cable to your TV Aerial outlet
3) Switch on the television using the rocker switch
located on the side of the TV
4) Install batteries in the remote control and press
the [STANDBY] button to turn on the TV.
The ‘First Time Installation’ menu should
now appear. If it does not, please press
[LCD-MENU] then 8-8-8-8 and the menu will
appear.
5) Press [OK] on the remote control whilst ‘OK’
is highlighted on screen.
Tuning will now take place.
If the TV finds some, but not all, of the Digital channels, the TV is
functioning correctly but the signal being received is not strong enough.
(The signal strength needs to be above 85% - you can see the signal strength
the TV is receiving when you change channels/ programmes) you will
need to increase the signal reception in order to recieve all of the channels
available. The most economical way to do this is by purchasing
and connecting a 'signal booster' in between the TV and the TV aerial socket.
If this does not solve the problem, you will need to upgrade the TV
aerial to a digital hi-gain compatible aerial
IMPORTANT - AFTER TUNING DO NOT PRESS ANY BUTTONS FOR 20 SECONDS SO THE CHANNEL
INFORMATION CAN BE STORED.
First Time Installation
Country
Language
Please ensure that the aerial is connected to the connector
labelled ‘ RF In ’ on the rear of the TV .Ensure that OK is
highlighted in yellow and press ‘OK’ on your remote .If after
this scan ,not all digital channels are found ,your aerial may
require a signal booster .alternatively ,upgrade your aerial
to a high gain digital version .
OK Cancel
UK
English
If no channels are found the following screen will appear,
please refer to additional information below.
TYPICAL SET-UP
Once you have connected a 'Signal booster' you will need
to retune the TV in order to receive all of the channels.
First Time Installation
Unfortunately the TV did not find any channels
Please check your aerial connection
and refer to the user manual
Do you wish to re tune your TV
Yes Do it next time
No
Signal Booster
Connect between TV and TV
Aerial socket
RF IN
INFO
19_17 english manual 10.pdf 21. 7. 2009 14:03:09