UMBRA RIMORCHI 07106/1VM, Инструкция по монтажу

Страница: 3 / 8

FITTING INSTRUCTIONS
07106/1VM
Remove below the vehicle any mastic from contact points between the chassis and the
tow bar; then paint mastic free pieces with rust inhibitor.
1. Remove the rear lights;
2. Remove the rear bumper and the reinforcement bar;
3. Insert inside the chassis-rails the tie-rods ''A'' with reference to the holes ''01'' and
''02'', insert the only screws ''01'' and fix them interposing the large washers;
4. ONLY FOR ZAFIRA TOURER : make a cut on the bumper (only for 07106/VM),
cut the bearings of the bumper as shown in the ATTACHMENT 1 ;
5. Cut the reinforcement bar;
6. Insert the spacer ''C'' on the already existing high screw and then back together
the reinforcement bar fixing it with the original bolts ''02'';
7. ONLY FOR ZAFIRA TOURER : Loosen the housing with the spare wheel placed
under the platform (if it is present) and move it as much as possible towards the
motor side;
8. ONLY FOR ZAFIRA TOURER : Tighten the housing with the spare wheel;
9. Place the cross bar ''B'' between the two tie rods referring to the holes ''03'', insert
the screws and fix them;
10. Tighten all bolts and nuts as shown in the enclosed layout;
11. Connect the wiring to the socket, following the car booklet's instructions “use and
maintenance” as shown in the enclosed wiring kit layout;
12. Back together the rear bumper and the lights.
INVISIBLE AND SWIVELING SOCKETHOLDER
07106/1VM
- OPEL ZAFIRA TOURER -
v. 1.0 01/01/11 P. 3 / 8