2.
1.
2.
3.
1.
2.
3.
4.
Connecting the SCSI Cable
For PC
Connect the SCSI cable to the SCSI interface card you installed.
Connect the other end of the SCSI cable to the scanner. It is OK to connect the cable to either SCSI
port on the scanner.
If your scanner is not chained to other SCSI devices, please connect the Terminator to the remaining
SCSI port of your scanner.
For Macintosh
You need to check to see which SCSI ID’s are already being used by other devices that are hooked up to
your computer. UMAX scanners are preset at SCSI ID 55. If no other device is using this address you can
proceed to install the scanner. If another device is already using this address you must change the SCSI ID
number on the scanner. To change the SCSI ID number (located at the back of the unit),
Make sure the scanner is turned off.
UMAX scanners are preset to SCSI ID #5. If you already have a SCSI device pre-set to SCSI ID #5,
see page 14 to change the ID number of your scanner. The section is titled, “Changing the SCSI ID
number”.
Connect the SCSI cable to your scanner then connect the other end of the cable to your Mac’s SCSI
port.
If your scanner is not chained to other devices, please connect the Terminator to the remaining SCSI
port of your scanner.
4
