Ultrawave Hygea 2850VM, Инструкция оператора

Страница: 6 / 40

5
Quick guide
Pour cold water into the bath so that it reaches the minimum tank fill line (but does not
go over the maximum fill line).
Add the required dose of detergent. Ultrawave recommend
Sonozyme detergent
sachets. Ultraclean M2 is also suitable.
Switch on the machine via the switch at the rear of the unit, on the left hand side,
above the electrical mains lead.
If the water is below the minimum temperature, the
Hygea 2850VM
will automatically
start degassing and heating the liquid.
Once the water is heated to the minimum operating temperature, the
Hygea 2850VM
is ready to use, although an extra degas cycle may be required.
Press the “ENTER” key to accept the cleaning cycle settings.
Select your operator identification.
Press the “ENTER” key to start the cleaning cycle.
At the end of the cleaning cycle, remove the basket holder from the
Hygea 2850VM
,
allow it to drain over the bath, then rinse the instruments under clean running water.
REMEMBER
- Always keep the bath full of liquid when in operation.
- Do not put hot water into the bath.
- Always use the baskets or instrument cassettes and holder.
- Never expose hands to cleaning solutions.
- Never use toxic, flammable, acidic, caustic or corrosive solutions.
- Never breathe the fumes from strong solutions.
- Rinse the instruments in clean water once the cycle is complete.
IMPORTANT: Once the cleaning cycle has finished, remove the cleaned items and rinse
them in clean running water.
Subjecting the bath to improper treatment or misuse will invalidate the warranty.