UTT-110B VOIP Gateway (SIP)
User manual
Copyright
©
2013, Shenzhen Ultrative Technologies Co., Ltd All rights reserved
17
Static IP address
When the operating mode using
When "Static", the correct
input on the configuration items available IP address, the device
defaults IP address: 192.169.0.1.
Static Mask
Mask with the IP
addresses, operating mode using
When
"Static", you must configure the mask, the default value Mask:
255.255.255.0.
Static Gateway
LAN device where the gateway IP
address, operating mode
using
When "Static", you must configure the gateway address, the
default value of the static gateway: 0.0.0.0.
PPPoE account
When
the operating mode using PPPoE
mode, enter the
correct PPPoE account available, no default value.
PPPoE password
When
the operating mode using PPPoE
mode, enter the
correct password PPPoE available, no default value.
PPPoE MTU
When the operating mode using PPPoE
mode, PPPoE MTU
default value 1480, the drop-down can be modified.
DNS switch
DNS
service
is off by default,
when you need to enable select
Open.
Preferred DNS
address
DNS server is turned
on, the preferred DNS address Default:
0.0.0.0, this can be modified in the preferred DNS server address.
Secondary DNS
address
DNS server is turned
on, the default secondary DNS addresses:
0.0.0.0, this can be modified alternate DNS server address.
SNTP switch
SNTP service
defaults to off,
select open when you need to
enable.
Preferred Time
Server
Preferred time server IP address
Default: 207.46.197.32, this
can be modified in the preferred time server IP address.
Standby time
servers
Standby time server IP address
Default:
0.0.0.0, this can be
modified spare time server IP address.
Time Table
Select the time
zone,
Default: time zone (GMT +08:00) Beijing,
pull-down can be modified.
Adaptive Switch
The default value is
an adaptive switch
is turned on, when you
close the WAN port can be configured manually operating speed and
duplex mode.
Work rate
Adaptive switch to select
off,
choose to work in this rate WAN
port.
Duplex mode
Adaptive switch to select
off,
in this selection WAN port duplex
mode.
Signalling three
QOS mode
The default value is
disabled, choose TOS or DSCP.
Signalling three
TOS
QOS signaling mode is selected as
three-TOS,
the
TOS
three signaling default value is 0, the effective range of values 0 ~
7.
IP
precedence
6
and
7 are
used for network control
All manuals and user guides at all-guides.com