www.ultratecfx.com
7
G3000 Screen Shots
Machine turned on warming up with no DMX input. Note
temperature bar graph shows low, Heater “H” is on and fog is
turned off DMX is unplugged and DMX LED (bottom left) is not
on.
Note error from trying to turn on machine that is not yet hot
enough.
Machine on with remote. Not fully heated (see temp bar and H is
on) so requesting 100% but getting 27%.
Machine on with DMX. Machine was fully heated (note bar graph)
but heater starts for 100% Actual flow.
Machine warming up with DMX attached. Note “DMX” on screen
with dmx address show below set at channel 1. Note valid DMX
red LED now on (lower left).
