www.ultratecfx.com
6
REM D100 A100
Fog 0:00 FHR
D=DEMAND; This value represents the user’s
requested fog output level from 1-100%
A=ACTUAL; This value represents the current level of
fog output in relation to DEMAND due to cooler block
temperatures.
F = LOW FLUID DETECTION; F will display when
sensor detects low fluid. Machine will continue to
run or can be set to shut off when sensor activates.
H = HEATING; H will display when the blocks
are heating up. H will disappear when block
is heated to desired temp.
R = RELAY; R appears when the G3000
is powering the LSG receptical.
CYCLE ON TIME
0:00 (mm:ss)
CYCLE OFF TIME
0:00 (mm:ss)
LSG PRE-FOG TIME
0:00 (mm:ss)
DMX Address: 511
Data 0 D+1 0
Set the desired time for the fog machine to
run, using the “+” or “-” buttons.
(0-10 Minutes)
Set the desired time for the fog machine to
stop, using the “+” or “-” buttons.
(0-30 Minutes)
When connected to an LSG, set the desired
time for the LSG to purge the CO2 line before
the G3000 begins to produce fog.
(0-2 Minutes)
Using the “+” or “-” buttons select the
desired valid DMX address. (0-511)
Data = fog rate controlled 0-100%,
DMX+1=LSG power on above 50%.
DMX
511
DMX Address
TEMPERATURE BAR
Displays the block
temperature.
Displays the Cycle On Time, Cycle
Off Time, and LSG Pre-Fog Time
0-255
0-255
128 - Relay
REM = Fog machine is controlled
currently by the remote
Fog = Machine is generating
fog. WIll read “Fog Off” when
currently not generating fog.
DMX=Fog machine is
controlled through DMX.
Remote bypassed.
