5
www.ultratecfx.com
The Show Control Remote Handset LED was designed to indicate operation modes. These are as
follows:
Slow Flashing Light:
Indicates unit is not ready to operate but still in heating mode, fog is not available
at this point.
Quick Flashing Light:
Indicates unit is ready to operate but still in heating mode, some fog is available
at this point.
Solid Light:
Indicates that the unit is ready to fog at full output.
Triple Pattern Flashing Light:
Indicates that the unit is in an over temperature condition and has shut
down.
No Light:
Indicates problems; a loss of power or remote is not connected. If these fail to correct the
problem, contact your local Ultratec Special Effects dealer.
Optional Show Control Remote Operation
No Light:
Indicates problems; a loss of power or remote is not
connected. If these fail to correct the problem, contact your local Ultratec Special Effects dealer.
Note:
To operate the Fog Burst using the Timer/ Duration Remote, the DMX Address must be set on
555. A show Control Remote and Timer/ Duration Remote cable may be extended
from the machine and operated effectively away from the Power Fog Industrial/9D. The maximum
recommended cable length is 225 Feet.
1) Power up fog machine and wait until fully heated (solid red LED on remote).
2) Turn Flow dial to desired fog output level.
3) Turn Duration dial above 50% to turn on Fog Burst.
4) Flip Smoke OFF/ON switch to ON position to start producing fog effect.
5) Reverse steps to turn OFF effects.
Optional Timer/ Duration Remote Operation
cont.
C 1 2 3
DRY CONTACTS
VARIFLOW
SMOKE
OFF
ON
Contacts
Variflow
LED
Smoke
OFF/ON
