ULTRASUN Q6-0, Руководство пользователя, Страница: 19 / 24

19
When effective life of your lamps and facial bulbs is over, or when there is an obvious decrease in the
tanning results, it is necessary to change the lamps and facial bulbs.
The top:
Remove the acrylic by carefully disassembling the synthetic strip on the whole length of the front
side. Now gently lift the acrylic from the top (with minimal two people) by taking the backside out of
the profile. Then the acrylic can be cleaned and the lamps can be changed.
The bed:
Remove the acrylic by disassembling the synthetic strip on the front and back side. Once the strip is
removed, the acrylic can simply be lifted and removed, preferably by two people.
When changing the lamps, turn the lamps in the lamp holders until the ‘click’ before you remove
them. When changing the lamps, also remove the dust from the machine (particularly around the
fans) and clean the acrylics from the inside. Read the assembly instructions for more information.
The facials (only for units with facial tanners):
To change the facial bulb, remove the cover from the top. This is possible by disassembling the two
synthetic profiles and taking the cover off. The reflector with the facial bulb inside can be completely
removed by removing the two screws (on both sides) from the reflector. At the same time the two
wires of the facial bulb must be disconnected. The facial bulb can be removed out of the pinch-spring
and replaced by a new one. Do not touch the glass of the facial bulb with your fingers. Remove the
dust and clean the white and blue filter with a
glass cleaning fluid.
Although this Ultrasun Q6 is equipped with high quality parts, there is a possibility the parts will get
exposed to mechanical erosion. When this happens, these parts need to be replaced. In the table
“ Technical product information” the specific article numbers of the lamps and facial burners are
listed. In the separately enclosed electrical scheme the article numbers of the electrical parts are
mentioned in the inscription. In order to keep your Ultrasun Q6 machine in compliance with the
standard, you have to make sure to change lamps, components and accessories with original lamps,
components and accessories only. Otherwise guarantee will be taken off as well as any responsibility
and any liability.
Service: Parts And Registration
Attention:
Make sure that the new lamps and facial bulbs are of the same type
as the previous ones!
Attention: When changing lamps, first remove the power supply, then remove
the acrylic.
Changing Lamps And Facial Bulbs