Ultrasonix SonixTablet, Руководство по обслуживанию

Страница: 90 / 123

Chapter 11: Maintenance 00.053.129, Revision C SonixTablet Service Manual
11-4
11.2.6 Transducer Holders and Cable Hooks
Apply a small amount of one of the following recommended cleaning solutions to a soft, non-abrasive cloth and
wipe off the transducer holders and cable hooks:
• water
• mild detergent (PH level at or near 7) and water solution.
11.2.7 System Filter
This filter should be cleaned approximately every three (3) to six (6) months. Periodically, the system will present a
cleaning reminder message. Always clean the filter when this reminder is presented.
Cleaning the system filter every three (3) to six (6) months helps to safely prolong the modulo fan filter cleaning
interval (refer to
Table 11-1 for the various maintenance procedure frequencies).
Use a vacuum cleaner to remove the dust from the system exhaust filters or vents. If a vacuum cleaner is not
available, dust off by hand or with an anti-static brush.
Cautions:
Power off and unplug the system prior to cleaning.
For best results, Ultrasonix recommends removing the transducer holders and cable hooks before cleaning ( 7.5.1 ).
This will allow the operator to clean all the various curves and folds in a more effective manner.
DO NOT apply cleaning solutions directly to the transducer holders and cable hooks.
Warning: Do not perform any internal system maintenance if the UPS breakers are turned on.
Caution: Power off and unplug the system prior to cleaning the fan filters