9
10
OPERATION
(Refer to pp. 7 & 8 for Parts Identification)
OPERATION
(Refer to pp. 7 & 8 for Parts Identification)
6. Turn the Dial Switch to the lowest setting (see Figure D),
the humidifier will begin to operate within a few seconds.
7. LED Nightlight/Indictor will illuminate within a few seconds
after the unit is turned on (see Figure E).
8. When the dial switch is turned further to the right, the mist
output will be set to the maximum level. You may notice a fine
mist of water around the unit when dial is set to the maximum
level. To eliminate that, simply turn the dial to the left to set
to a lower level.
9. When the desired humidity level is reached (50%), the
dial switch can be set to a lower level by turning to the left.
10. When the water bottle is almost empty, it will slightly tip
to the side. This is normal. Just remove the empty water bottle.
Then unscrew the bottle adapter and fill up the bottle with
water (distilled water or water with low mineral content is
recommended). Then place the adaptor back on and place
the bottle upside down. Turn the unit back on to the desired
level.
11. In case there is no water in the bottle, the humidifier will
automatically shut off. Once the water is refilled, the humidifier
will start working again.
Figure D
OPERATION
NOTE: Before the humidifier is used, check all accessories
are included:
• 120~240VAC Adaptor
• cleaning brush
• storage pouch
1. Fold out the feet under humidifier and make sure
feet are firmly opened and fixed under the humidifier
(see Figure A). The feet stabilize the humidifier with a
bottle on the top.
2. Ensure the mist/nozzle outlet is in the open position,
otherwise humidifier will not work.
3. 17oz / 0.5 liter water bottle is recommended.
It is recommended to use only bottled or
distilled water.
4. Insert water adaptor into the water bottle,
then quickly place the other side of water adaptor
into the humidifier (see Figure B+C). DO NOT
over tighten the water adaptor. The water bottle
should not be squeezed since it will cause the
humidifier to overflow.
5. Plug AC adaptor directly into wall outlet.
Figure A
Figure B
Figure C
Figure E
LED Nightlight/
Indicator
