Step 7
Pre
Pre
Pre
Pre----flash set
flash set
flash set
flash set----up.
up.
up.
up.
Your camera’s pre-flash may be set from zero pre-flash up to as many as four. To determine your
camera’s setting, first turn on the Strobe. You will note the red LED is defaulted from the factory to the
bottom light (0 positions).
Press the pre-flash setting button until red LED illuminate at the top position (4) this will set the strobe
to recognize 4 pre-flashes. In a darkened room take a picture of the Strobe with your camera on forced
flash or auto setting. If the Strobe flash has NOT fired your camera is set at less than 4 pre-flashes (if
uncertain immediately check the green ready-light - it will remain on if it has NOT fired), IF THE
STROBE HAS FIRED THIS SETTING IS THE CORRECT ONE FOR YOUR CAMERA – DO NOT CHANGE.
If the Strobe has not fired, REPEAT the above procedure by dropping one position EACH TIME until the
Strobe fires; this will identify the proper pre-flash setting that matches your camera. DO NOT CHANGE
THIS SETTING; THE STROBE WILL NOW DEFAULT TO THIS SETTING AUTOMATICALLY WHENEVER
IT IS TURNED ON.
It is prudent to check this setting before each dive to assure that you haven’t accidentally changed the
setting.
Step 8
Power output adjustment.
Power output adjustment.
Power output adjustment.
Power output adjustment.
You can easily adjust the flash output power at 20%, 40%, 60% , 80% or full power at 100% so that you
can adapt to the lighting conditions of the environment and/or input greater creativity. Simply pushing
the power “up” or “down” button (either press once or continuously press the “up” or “down” button)
to cycles the power output. The green LED’s correspond to the graphics imprinted aside by the light.
The output power level indicator can also be seen from the side window.
