ULTRAMAX
ULTRAPOWER UXDS-3
UNDERWATER DIGITAL STROBE LIGHT
QUICK START GUIDE
Preparing the UXDS
Preparing the UXDS
Preparing the UXDS
Preparing the UXDS----3
3
3
3 Strobe for Use
Strobe for Use
Strobe for Use
Strobe for Use
Step 1
Battery installation
Battery installation
Battery installation
Battery installation
Unscrew the large knob giving access to the battery compartment.
You will feel some resistance as there are two O-rings providing positive protection against leakage.
Upon removal you can see the battery holder inside the compartment – slide this out
Step 2
Install four AA batteries in the holder paying close attention to polarity
(CAUTION : Installing batteries in WRONG polarities may cause heat to damage the battery holder and
the electronic components. Please install the batteries according to the polarity icons embossed on
both sides of the battery holder. Damage caused by incorrect battery installation is NOT covered
under warranty.)
Step 3
Following the position markings, snap the two Battery Holder Cover Plates onto both sides of the
Battery Holder
