Ultraframe Classic roof, Руководство по установке

Страница: 11 / 52

11
Straight Union
Inser on depth mark
3
Assemble & cut gutter to size - If over 4000mm span then the
gutter must be split by a straight union. Insert gutter assembly and
rotate into position (see Step 2). DO NOT slide gutter into union
must always roll and lock.
NOTE: Sliding can result in damage to the seal
5
Build up gutter assembly; gutter & 135° union. Snap the integral
clips on the unions over the gutter.
Insert gutter assembly into brackets using “step 2b” assembly
methods. 135° angle to overhang then.
135° angle to overhang, Slide gutter assembly towards 90° union
and then snap the integral clips on the unions (Similar to step 2c).
NOTE: DO NOT slide gutter into union must always roll and lock.
GEORGIAN INSTALLATION
SECTION 4
4
Build up gutter assembly; gutter & 135° union. Snap the integral
clips on the unions over the gutter and repeat similarly to step 2b
& 2c.
NOTE: Remember to work to the insertion lines.
6
This should be the final step in the gutter system installation for a
Georgian or Victorian, as the opposing side will be repeated by the
previous steps within this guide. The gutter will essentially meet up
at this step.
Cut gutter to length and insert gutter assembly into brackets
using “step 2b” assembly methods.
NOTE: DO NOT slide gutter into union must always roll and lock.
Fig. 2
Insert gutter assembly and roll into position, critical to locate the
back edge of each section of gutter into the slot in the gutter
bracket first.
NOTE: DO NOT push fit any union onto gutter as this can result in
leaks.
IMPORTANT:
Ensure all lengths of gutter fit to the marked insertion line
seen in all unions and box gutter adaptors. (See Fig. 2)
Ensure to lubricate all rubber seals prior to inserting the
gutter.
Must not slide gutter into union must always roll and lock.
DO NOT Silicone Seal, this would prevent expansion/
contraction.
If the gutter is not allowed to freely expand, distortion can
occur.