- 17 -
The Firmware Upgrade Utility
To upgrade the GammaView’s firmware, do the following:
1. From a computer that is not part of your KVM installation,
download the latest Firmware Upgrade package for the KVM
from our Internet support site (
www.ultraproducts.com
).
2. Disconnect the GammaView from your KVM installation.
Press and hold the Remote Port Selector’s pushbutton. While
you are still holding the pushbutton, connect the KVM cable’s
purple USB connector to a USB port on the computer you
have downloaded the Firmware Upgrade package to.
3. The GammaView now enters Firmware Upgrade Mode. The
two Ports LEDs flash together to indicate that the unit is in
Firmware Upgrade Mode.
Note:
While the GammaView is in Firmware Upgrade Mode,
normal keyboard and mouse functions are suspended.
You must complete the firmware upgrade or exit
Firmware Upgrade Mode to regain normal control of the
console.
4. Run the Firmware Upgrade Package file. The
Firmware
Upgrade Utility
Welcome screen appears.
5. Read the License Agreement and enable to
I Agree
button.
6. Click
Next
to continue. The Firmware Upgrade Utility main
screen appears. All the devices capable of being upgraded by
the package are listed in the
Devices List
panel.
7. Select your device. Its description appears in the Device
Description panel. Click
Next
to perform the upgrade.
As the upgrade proceeds, status messages appear in the
Status Messages panel, and the progress towards completion
is shown in the
Progress
bar.
8. After the upgrade has completed, a screen appears to inform
you that procedure was successful. Click
Finish
to close the
Firmware Upgrade Utility.
9. Set up your KVM installation again. See
Installation
, page 11.
