24. Position the spare tire bar (10) to the U channel of tow bar as shown below then secure it
with two M10*25 bolts,
￠
10 flat washers, and M10 nuts(A, B, C in bolt bag set 1).
25. Bolt the coupler (15) to the coupler base (11) with M10*90 hex bolts, flat washers, and M10
nuts (K, B, C in bolt bag 5(‘
Ⅴ
’)), attach the safety chain (16) to the coupler with bolt M10*90
by putting the bolt through the center link of the chain, lock it. NOTE: Make sure the safety
chain is the same length on each side.
26. Place the coupler with coupler base (15, 11) on the front of the tow bar and secure with
M10*25 bolts,
￠
10 flat washer, and M10 nuts (A, B, C in bolt bag set 1) as shown below.
4' x 8'FOLDING ALUMINUM TRAILER KIT
Owner’s Manual
4' x 8'FOLDING ALUMINUM TRAILER KIT
Owner’s Manual
9 of 16
27. Lock coupler trigger using safety pin (N) through the trigger hole then insert the 2mm R pin
(O) through the end hole of safety pin to lock the coupler.
28. Remove the left tail light (24L) from the left tail light bracket (22L) then attach the bracket to
left side rail with M10*25 bolts,
￠
10 flat washers, and M10 nuts(A, B, C in bolt bag set 1) as
shown below. Install the left tail light (24L) and license plate holder (23) (with clear lens
facing down) with M6 padded nuts (G) on the light.
29. Remove the right tail light (24R) from the right tail light bracket (22R), attach bracket to right
side rail with M10*25 bolts,
￠
10 flat washers, and M10 nuts(A, B, C in bolt bag set 1) also as
shown below. Install the right tail light with M6 padded nuts (G) on the light.
30. Remove the lenses of the side running lights (6), feed the wire through the hole in the center
of the light and the center hole in the frame and attach the lights to the frame with self-tap-
ping screws (F).Replace the lenses on the lights.
TRAILER LIGHT KIT
WINDOW DIAGRAM AND INSTRUCTION
Check alignment of all parts and install 4-wire vehicle connector in trunk area of your car.
Locate the connector plug near the hitch ball and lay out wires . Connect the brown wire to tail
light by stripping , wrapping and taping connector , similarly connect the yellow wire to left
single & stop light wire and green wire to the right single & stop light wire. Some foreign vehicle
may require an adaptor to convert their 5-wire system to 4-wire vehicle connector .
8 of 16
