Transmitter Programming
Note: The system is capable of learning up to 3 different transmitter codes.
To place the system in Transmitter Code Learning Mode:
1.
Open the hood.
2.
Start with ignition key in the
“Off”
position, turn the ignition key
“On/Off”, “On/Off”,
“On”
and leave in the
“On”
position.
3.
Press and hold the brake down for 5 seconds until lights flash 5 times and and the
LED
comes
“ON”
solid.
The system is now in Programming Mode and is ready to accept transmitter
programming.
To program new Transmitters:
Press button #1 of each transmitter once momentarily - the system will respond with 1
light flash and one chirp/honk. The LED will turn
“Off”
momentarily to confirm that it has
accepted the new code.
Note:
If programming only one set of transmitters, upon entering into programming
mode, press button 1 of the transmitter 3 times. This will fill up all memory locations.
To exit Transmitter Code Learning Mode:
The system will automatically exit Programming Mode for any of the following conditions:
1. The ignition is turned
“Off”
.
2. No new transmitter button has been pressed within 5 seconds.
3. After the 3rd transmitter has been programmed.
The LED will respond by turning
“Off”,
indicating that it has exited programming mode.
Important:
Once the system has exited Programming Mode, turn the ignition key to the
“Off”
position and test transmitter.
TRANSMITTER PROGRAMMING
PROGRAMMING - Tach Settings
Voltage Sense Mode
(System Default)
Note:
Ensure that program switch #1 is in the
“Off”
position.
The recommended setting is Voltage Sense Mode. This method requires no additional wiring.
Note:
In Voltage Sense Mode, do
NOT
connect the
Black/White
Tach Sense Wire.
Tach Sense / Tach Learning Mode
Note:
Ensure that program switch #1 is in the
“Off”
position.
In this mode the system will sense and/or learn the tach pulses from the vehicle.
Connect the
Black/white
Tach wire and follow Tach Learning Procedure. See Installer Program Menu
Tachless Timer Mode
Note:
Ensure that program switch #1 is in the
“Off”
position.
In this mode the starter will stop cranking after a pre-determined crank time. (See Below).
If Tachless Timer Mode does not start the car properly, proceed into:
Alternator Sensing Mode
Note:
Ensure that program switch #1 is in the
“On”
position.
In this mode the system will sense the change in voltage from Ground to +12 VDC when the vehicle has
started and subsequently stop cranking. Locate wire on alternator that goes from ground to 12V+ when
vehicle has started
