Ultra Reef UKD-200, Инструкция по эксплуатации

Страница: 10 / 12

ULTRA REEF
www.ultrareef.it
10
To increase or decrease the foam level open or close
the flow valve as shown on the regulation screw.
Warning: The adjustment must be done with little
variation over time. Allow at least 30 minutes after
each full turn of the regulation screw.
Close the flow valve until the foam reaches the top of
the skimmer without overflowing.
Replace the cup and cover. For the first week, the cup
will fill up quickly and debris collected will be light in
colour.
After about a week, the collected liquid should
become definitely darker and should accumulate more
slowly.
Warning: In just set up tanks, the skimmer may not
produce foam for a few weeks. This inhibition is due to
the residues of the oils used for the realization of the
hoses (rubber hoses).
HIGH AIR FLOW
This series of skimmers treats a considerable quantity
of air, making it more sensitive to the water surface
tension. Product dosing or the simple contact of the
hands with water may cause variations in the level of
the foam even for a few hours.
It is important during this time to do not adjust the
level of the foam otherwise, once the skimming is
stabilized, it may flood the collection cup.
Warning: Adjust the skimmer away from maintenance
or product dosing times.
SETTING
Skimmers are often subject to malfunctions related to
the situation of the tank. These phenomena are
normal and usually does not pose a risk to the tanks.
Warning: To solve of any problems during use, contact
the retailer or the distributors where you have
purchase the product.
Increase the level (close the valve) to accelerate the
skimming if the amount of liquid collected in the cup is
too dense or insufficient. This is commonly referred to
as "wet skimming".
Conversely, decreased the level (open the gate) to
reduce the skimming if the glass is filled too quickly
and the accumulated fluid is too light. This is
commonly referred to as "dry skimming".
Warning: Finding the right point of skimming is
extremely difficult and requires some experience. For
the first time it is normal to have difficulty regulating
the product.
It is possible to act on the air adjustment screw to
increase or decrease the amount of air treated.
Warning: Do not connect pipes, filters or other
systems to the air suction line. Any modification could
compromise the operation of the skimmer
Rotate the adjusting screw clockwise to decrease the
intake of air. Otherwise, rotate the adjusting screw in
an anti-clockwise to increase the air intake.
Warning: air regulation recommended only for
EXPERTS users, an improper adjustment may limit the
performance of the skimmer or seriously damage the
pump.
It is advisable to empty the glass as soon as the liquid
level reaches 2-3cm harvest, which should occur at
least weekly.
PUMPS WITH CONTROLLER
Warning: For any Information to use the controller,
refer to the controller manufacturer's instruction
manual.
Adjusting of the pump allows you to change the
performance of the skimmer by simultaneously adjust
the amount of aspirated air and treated water.
Reducing the pump speed decreases the extraction
capacity and the consumption of the skimmer. This
solution is useful for feeding or tanks maturation time.
Conversely, increasing the speed of the pump
increases the extraction capacity and the consumption
of the skimmer.
After each variation of speed, it is necessary to wait
for the foam to stabilize. Change the speed of one step
(one LED) every 2 hours.
MAINTENANCE
Warning: An increase in the noise or vibration of the
product are caused by occlusion on the air intake or