WiMo Antennen und Elektronik GmbH
Am Gäxwald 14, D-76863 Herxheim Tel. (07276) 96680 FAX 9668-11
http://www.wimo.com e-mail: [email protected]
4
INSTALLATION OF ELEMENTS ON MOTOR UNIT
Before inserting the elements in the motor unit it is necessary to fix the PVC guide tube.
During this operation it is necessary that the element remains aligned to the engine, if your
set-up assembly does not allow this, the help of a second person is absolutely needed to
support the element during the insertion of the guide tube.
Applied during the construction phase, the inner PVC tube to be inserted jnto the engine
contains a bi-adhesive that will keep the junction steady in time (fig.4)
Push the PVC pipe until it reaches its maximum insertion (Figure 1)
Carefully push the element into the motor unit until it stops (Fig.2-3) and tighten the
clamp of the rubber cap.
Fig.1
Fig.2
Fig.3
Important note:
Be carefully while mounting the guide tubes.
In case of possible detachment of even a single tube, the copper tape will bend inevitably
compromising the unit's motor functions.
……..
Fig.4
Bi-
NOTE:
T
he procedures relating to the installation of guide tubes
are common to all models with folded elements.
- 2 EL. 6-40
- UB-20
- UB-40
- UB-50
