FIXING / ADJUSTMENT OF “T” SUPPORT
………………………………………………………………………………………...
Insert the T shaped tube to the end of the antenna central element.
The tube has sufficient length to slide the element inside, this allows a
telescopic adjustment in the direction of the arrows, useful to set the correct position of the T so
that the whole side panel stays perfectly lined up (only aesthetic factor) any not perfect
alignment will not compromise in any way the antenna operation.
Once the exact spot is found, apply the heat shrink sleeve to lock the T-tube to the end
of the telescopic element.
Move laterally the T inserted into the side panel in the sense of <
arrows
> to adjust
parallelism between the antenna elements, it is not necessary to lock the T element, you can also
leave it free to slide, so it will always find its natural position.
!
7
Fig.4 Fig.5 Fig.6 Fig.7
Combine the 1400 mm. pipes placing the 10 cm small tubes exactly at half junction (fig.4-5)
Slide the sleeves on joints and heat up to the correct temperature (Figure 6)
Drill a small 2-3 mm. hole on the same axis in the center in both junctions (fig.7)
NOTE
: important to check that the holes are facing down before heating conduits that hold whole side
element to the curves
Regolare nel senso delle
frecce per allineare
l’elemento laterale prima di
fissare la giunzione
regolare nel senso delle
frecce affinché
l’elemento centrale sia
pararrello agli elementi
esterni
