!
4
INSTALLATION OF ELEMENTS ON MOTOR UNIT
Before inserting the elements in the motor unit it is necessary to fix the PVC guide tube.
During this operation it is necessary that the element remains aligned to the engine, if your
set-up assembly does not allow this, it is absolutely needed the help of a second person to
support the element during the insertion of the guide tube.
The inner PVC tube to be inserted to the engine contains a bi-adhesive applied during the
construction phase that will keep the junction steady in time (fig.4)
Push the PVC pipe until it reaches its maximum insertion (Figure 1)
Place the element in the motor unit until it stops (Fig.2-3) and tighten the clamp of the
rubber cap.
Fig.1 Fig.2 Fig.3
Important note:
you must carefully mounting the guide tubes.
In case of possible detachment of even a single tube, the copper tape will bend inevitably
compromising the unit's motor functions.
……..
Fig.4
Bi-adhesive
NOTE:
T
he procedures relating to the installation of guide tubes
are common to all models with folded elements.
- 2 EL. 6-40
- UB-20
- UB-40
- UB-50
