6 GB
rubber hammer can help with this). Then fit the
end stoppers. (See Fig. A)
2) Insert the down rod section (without plug)
4
into the central linking piece
1
. Put the pin
6
through the lowest hole and fit the plate
8
(See Fig. B).
3) Load rim with tyre (See Fig. C). Proceed in
same sequence for other tyres.
4) Now, put in place end rod section (with stop-
per)
3
(See Fig. D). Proceed as described
above, until all 4 tyres are properly stored (See
Fig. E & F).
5) If you would like to make use the storage con-
tainer
7
for storing assembly items, carefully
remove the stopper from the end rod section
3
(e.g. with the aid of a screwdriver). Place
the storage container
7
on the end rod sec-
tion
3
.
notes:
the two individual parts of the storage
container
7
must be joined with the corre-
sponding screws
9
before being used. For
this, please use a crosshead screwdriver, size
PH1.
Q
Instructions for use
of accessories
The tyre chips
13
are placed on the valves as a
simple means of labelling when storing tyres.
The air pressure gauge
11
is used for taking rough
measurements. If needed, go to the nearest petrol
station to check the pressure more accurately.
use:
push in the measuring rod of the air pressure
gauge
11
fully before use. Then place on valve
and read off pressure in desired units on the meas-
uring rod. If the pressure is too high, the valve can
be pressed in using the button on the side of the
gauge to let out air. The tread gauge
10
is used
for taking rough measurements. Go to a garage if
necessary. The required profile measurements may
vary by country. Therefore please find out about
the specific regulations in your country.
The storage container
7
is for the storage of as-
sembly accessories.
Q
Maintenance and care
j
The tyre stand and the central linking piece
1
should be checked regularly for damage or
wear.
j
Use a damp cloth for cleaning. Do not use any
cleaning fluids, solvents or sharp objects.
Q
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
