ULTIMATE SPEED 303565, Инструкции по эксплуатации и безопасности

Страница: 16 / 54

16 GB/IE
Q
Maintenance and storage
Q
Topping up the
hydraulic oil / greasing
Note: Use only hydraulic oil that complies with
ISO VG 15.
Stand the vehicle jack upright on a level,
flat surface.
Screw the extension screw
2
completely
down into the jack body.
Place the rod
7
with oval opening on to
the release valve
5
and turn the rod anti-
clockwise (Fig. C) until the support plate
1
is fully lowered.
Pull the oil plug
8
out of the oil reservoir.
Introduce hydraulic oil from a suitable ves-
sel into the oil reservoir. Fill the hydraulic oil
reservoir up to the bottom edge of the filling
opening.
Remove any air present in the hydraulic sys-
tem. To do this follow steps 3–4 in section
on “Removing air from the system”.
Replace the oil plug
8
back into the oil
reservoir opening.
Grease all moving parts on the vehicle jack
regularly to prevent corrosion.
Top up with approximately 100–105 ml oil
if all the oil has been used up.
Note: The lifetime of three years expires,
if the car jack get not checked by qualified
specialist.
Defective hydraulic vehicle jacks must be
repaired by a specialist workshop only.
Never attempy to repair the hydraulic vehicle
jack yourself.
Q
Removing air from
the hydraulic system
Air in the hydraulic system may detrimentally af-
fect the proper functioning of the vehicle jack.
Proceed as follows to remove air from
the hydraulic system:
1. Place the rod
7
with oval opening on to
the release valve
5
and turn the rod anti-
clockwise (Fig. C) until the support plate
1
is fully lowered.
2. Pull the oil plug
8
out of the oil reservoir.
3. Guide the lifting handle
6
into the lifting
handle socket
3
and pump it up and down
several times to allow any air to escape.
4. Place the rod
7
with oval opening on to
the release valve
5
and turn the rod clock-
wise (Fig. C). The release valve
5
is now
closed again.
5. Replace the oil plug
8
back into the oil
reservoir opening.
6. If necessary, repeat steps 1–5 until all the
air has escaped.
Q
Storing
Place the rod
7
with oval opening on to
the release valve
5
and turn the rod anti-
clockwise (Fig. C) until the support plate
1
is fully lowered.
Screw the extension screw
2
completely
down into the jack body.
Store the hydraulic vehicle jack and the lifting
handle in a dry environment and protected
from moisture.
Ensure that the support plate
1
is fully
lowered and the extension screw
2
is com-
pletely screwed in before you put away the
vehicle jack. This will prevent the oil escap-
ing from the oil plug
8
.
Grease all moving parts on the vehicle jack
regularly to prevent corrosion.
Q
Troubleshooting
= Fault
= Cause
= Remedy
= The vehicle jack does not raise the vehicle
at all or does not raise it high enough.
= The release valve
5
was not properly closed.