Comments
0 comments
Article is closed for comments.
Articles in this section
See more
Repeat this for the other axles. Make sure to move the print head to the opposite side
each time.
The axles should not move at all. If one of the axles does move, you can observe a
ticking noise of the pulleys hitting the frame. In this case it is recommended to calibrate
the print head.
Was this article helpful?
0 out of 8 found this helpful
Update the Ultimaker 3 firmware
Ultimaker 3 firmware release notes
Replace the build plate clamps of the Ultimaker 3
Replace the radial fans of the Ultimaker 3
Replace the axial fan of the Ultimaker 3
Replace the tube coupling collet of the Ultimaker 3
Replace the clamp clip of the Ultimaker 3
Replace the Bowden tubes on the Ultimaker 3
Clean the feeders on the Ultimaker 3
Lubricate the lead screw of the Z motor on the Ultimaker 3
Check for play on the axles of the Ultimaker 3 – ...
https://support.ultimaker.com/hc/en-us/articles/...
2 of 3
12/15/20, 1:54 PM
