15
[Figure 7] - Turn gas control to “OFF”.
[Figure 8] - Press, hold and turn to low.
WARNING:
Before lighting, remove weather cover and remove lid
when applicable.
WARNING:
DO NOT stand with your head or arms over the fire pit
at any time.
1. Make sure gas control knob on unit is set to “OFF”, then turn on
the gas supply. Open the tank valve fully by slowly turning the handle
counterclockwise. [Figure 7] Purge the gas supply line of any trapped
air and check for leaks prior to the first lighting of the unit. See
“Lighting Safety” section for details.
2. To ignite, push and hold gas control knob on unit for 3 - 5 seconds
while turning to “LOW” and once ignited continuing to depress the
gas control knob for an additional 5-10 seconds before releasing. The
flame should stay lit. This will actuate the thermocouple. [Figure 8]
NOTE: The built in thermocouple safety device needs to warm up to
engage, ensuring the gas will be shut off in the event of the unit being
tipped over or blown out.
3. If igniter does not light burner, replace AA battery or use a long
match or long butane lighter.
4. Adjust flame to desired level with the gas control knob on the unit.
5. After operation, turn all gas knobs to the “OFF” position and push
the ON/OFF switch to off. Remember to turn the valve on top of the
gas cylinder to the “OFF” position.
IF BURNER DOES NOT IGNITE:
If ignition is not immediate, push and turn the control knob
clockwise to “OFF”. The gas supply will automatically shut off after
approximately 10 seconds (+/- 3 seconds) if a flame does not start or
it is extinguished. If this happens, wait 5 minutes for gas fumes to clear
and re-try or refer to the troubleshooting section if the unit does not
re-start. If problem cannot be resolved, do not attempt to operate the
appliance; contact your dealer or approved service center.
LIGHTING INSTRUCTIONS
