ujk technology 103570, Оригинальное руководство пользователя

Страница: 2 / 20

Index of Contents 02
Parts Breakdown 03
UJK Technology OTORO Palm Router Table Kits 04
Specification 04
Assembly 05-06
Router Assembly/Setup
07-08
Parts Illustration & Description 09-10-11
Router Table Modes
Planing Mode 12
Planing Width Mode 13
Moulding Mode 14
Planing Width Tips 15
Exploded Diagram/Parts List 16-17
Notes 18-19
Index
2
The UJK Technology Otoro Palm Router Table is a
unique and ingenious piece of equipment, well
suited to the needs of any craftsperson wishing to
make smaller sized, precision components. This
makes it ideal for model makers, dolls house
constructors or anyone who needs to accurately
machine small sections of timber.
It’s designed to be used with a quarter inch router/
trimmer, either the Bosch GKF 600 (702335), the
Makita RT0700CX2 (501867) or the DeWalt D26240K
(952707). The Makita router requires the use of a sleeve
adaptor which is supplied with the router table. Coarse
and Fine Feed adjustments are provided to set the
height of the cutter above the table.
Once the table has been assembled, it can be
conveniently stored in a small cupboard and can
be quickly clamped to any surface in a matter of
seconds, which means that it can be used almost
anywhere in the house. Install the router, connect the
dust extractor to the 48.5mm port, and you’re ready for
business! Three modes of operation are possible with
this router table; preparing an edge, planing the board
to width and moulding.
Edge preparation - The Rear Planing Fence consists of
two sections; a fixed outfeed and an adjustable infeed.
The adjustable part works by using a ‘folding wedge’
arrangement, where one slides against the other to create
the depth of cut. Accuracy is assured by a 10:1 scale, thus
moving and locking the leading wedge 10mm produces a
cut of 1mm. A featherboard is included to keep the timber
securely against the fence.
Width planing - The Rear Planing Fence is replaced by
the Rear Featherboard Fence; The Front Fence, complete
with a similar folding wedge adjustment is used to set
the planing width of the board. It should be noted that in
this unconventional, twin fence mode of routing, the Rear
Featherboard Fence pushes the material away from the
cutter so that it’s forced onto the adjustable Front Fence.
In a normal router table, one fence is used and the
material is forced towards it by the featherboards. Thin
strips of material can also be prepared to thickness by
sticking them to a wider carrier using double sided tape.
Moulding - Mouldings can be produced by using the
Rear Planing Fence in the same mode of operation as
edge preparation. Different sized cutters can be used by
changing the table insert, a selection of which can be
conveniently stored underneath the table.
Introduction
UJK Technology OTORO Palm Router Table has been licensed by OTORO
DESIGN INC., Japan, based on patented design of OTORO Multipurpose
Compact Router Table TTX2.
The symbols below advise the correct safety procedures when using this machine.
Fully read manual
and safety instructions
before use
Eye protection
should be worn
Ear protection
should be worn
HAZARD Dust mask
should be worn