Notice
Design for monitoring the third party industrial detector status via DI/DO (dry contact) digital signal.
Troubleshooting
Problem
Solution
Specifications
Wireless DI Transducer
a. Make sure the battery power is adequate and wires’ connections are properly connected.
b. Reset to factory default (Please see
Installation
,
III. Device Deletion
), and re-join to the
system.
c. If the problem persists, please contact your local distributor.
Check the wireless signal via RSSI and the distance between device and Gateway/Router
(line of sight) is 200 meters (max.). If there is any obstructions (i.e. walls or metal objects)
between the devices, the distance will be shorter. Users can move the device closer or add
a Router, then try again.
Electrical Specifications
Communication Protocol / Frequency
Operation Range
Operating Voltage
Battery Type
Battery Life
Input Signal
LED Indicator
Environmental Requirement
Operating Temperature
Storage Temperature
Humidity
Mechanical Specifications
Dimension (W x H x D)
Weight (without battery)
Wire Assignment
Wire 1- (Red)
Wire 2- (White)
Zigbee Pro ZHA1.2 / 2.4 GHz ISM band
Up to 200 meters (LOS)
3 VDC
CR123A x 1
Up to 1 year
Dry contact x 1
Red
0°C to 40°C
-20°C to 70°C
90% RH Max., Non-Condensing
71.9 x 48.8 x 21.5 mm
32g
Dry contact Input (Positive)
Dry contact Input (Negative)
Installation (Continue)
III. Device Deletion (Back to default settings)
3. Delete the device from the website.
(See the features on the right side.)
4. Long press the SET button at the
back of the device. The LED indicator
blinks red and then turns off. After
6 seconds, the LED indicator blinks
red, indicating the deletion process
is sucessful. (Please complete the
procedure in 3 minutes.)
1
2
3
Note:
After device deletion, it will back to auto joining mode.
The LED indicator lights
abnormally when linking to
the system
Cannot link to the system